Sea Clear Power Marine Graph Wiring Harness

The first wiring harness ever made for the sole purpose of wiring up your Marine Electronics. Tired of poor image quality? Tired of your units blinking? Tired of your units and accessories for them not being on one system? Tired of waiting on your units taking 30 seconds to start reading structure scan after coming off the pad?  Get with us today to solve all these problems with clean power and "sea" the difference with this reliable 10 AWG marine wire harness.

Compatible with all brands and accessories including Humminbird, Garmin, and Lowrance, the Sea Clear wiring system allows you to tie all of your graphs and electronics into one 10 AWG harness.

This is the Bass Boat version which work on any boat up to 21 feet long where the battery is located on the back starboard.
Accomodates 3 devices at the console and 3 devices at the bow. For more devices. use Sea Clear Power Adapter Kit

Typically you will need one (1) fuse holder for every electronic device you add to the circuit. To get the highest performance, Sea Clear recommends using the Sea Clear Inline Corrosion Resistant Fuse Holders, so every processor on your boat gets the clean and adequate power it needs to work properly. Check out the Sea Clear Power Wiring Harness with Switch & Jumper Install Walkthrough in the Product Video section for a full installation breakdown.

Come with:

• 26ft Wiring harness built around 10 AWG stranded marine wire
• A battery Disconnect Switch, 12V-48V
• A 10 AWG 20" jumper cable (to go from battery positive post to the battery disconnect switch